RESET MAC TO FACTORY SETTINGS FROM CLI PLUS

RESET MAC TO FACTORY SETTINGS FROM CLI PLUS

To restore power, use the CLI command - ' poe mode plus ' on the interface.įrom the Web interface ( example on Port 2 ). Switch# sh poe int gig 1/12 Interface PD Class Pwr Req Pwr Alloc Port Status Power Used Current Used Priority - GigabitEthernet 1/12 2 3.9 3.9 PoE turned ON 2.5 47 Low Total - 3.9 3.9 - 2.5 47 Switch# con t Switch(config)# int gig 1/12 Switch(config-if)# no poe mode Switch(config-if)# exit Switch(config)# exit Switch# sh poe int gig 1/12 Interface PD Class Pwr Req Pwr Alloc Port Status Power Used Current Used Priority - GigabitEthernet 1/12 - 0.0 0.0 PoE turned OFF - PoE disabled 0.0 0 Low Total - 0.0 0.0 - 0.0 0 Question: How do you turn PoE power off to a PoE device connected to an ASE switch? NV1560# show run interface GigabitEthernet 1/4ĭescription Connected to Customer LAN and VoIP Phones Port security is the reason for the mac addresses being static here.

MAC address learned on a port are normally shown as dynamic ( dynamically learned ) MAC addresses, but this will change with some security settings. Why are my devices that were learned on the port, showing static MAC addresses in the MAC Table? Save these modified settings to a session profile and use that profile each time you are working with an ASE switch to use the Backspace key normally. NOTE: If you do not save these settings to a session profile on the main PuTTy screen, you will have to repeat these steps to use the Backspace key as normal each time you open a PuTTy session. You can close the settings menu and use the Backspace key as normal for the session. Once the changes have been applied, you can close the configuration menu and continue to use PuTTy as normal by using one of the following options: To apply these changes, select Apply at the bottom of the menu.ģ.

This operation reassigns the CTRL + H function to the Backspace key so that the Backspace key functions normally. Next, in The Backspace key configuration, change the default setting from Control-? (127) to Control-H as shown below. If you already have an active PuTTy session open, you can right-click on the menu bar at the top of the application and select Change Settings to open the PuTTy Reconfiguration menu, and then select the Keyboard setting.Ģ. When opening a new PuTTy session, select the Keyboard setting in the PuTTy Configuration menu. You can reconfigure these settings in a new PuTTy session or in an existing session by following these steps:ġ. The process for reconfiguring your PuTTy session to preserve the Backspace key functionality revolves around redefining the Backspace key keyboard settings for the PuTTy session. The following instructions are specific to PuTTy, but similar reconfigurations in the terminal emulation tool of your choice can be achieved by making the same adjustments. This short article presents a workaround to this issue that allows you to reconfigure the keyboard settings in your SSH session so that you can use the Backspace key normally. These issues are currently being addressed, but until they are resolved the backspace function can only be achieved using the Delete key or by pressing CTRL + H. In the ASE (v4.4-44 and earlier) switches, when using terminal emulation applications to manage the switch, the Backspace key does not function normally due to issues in the code.

Reset mac to factory settings from cli